Configure an Integrated System
An integrated system is a plug-in component that links a third-party system to Runtime. Integrated systems have different requirements for installation and you should have the manufacturers documentation to refer to when necessary.
The Integrated Systems come pre-loaded with the settings that are particular to each manufacturers equipment. For further information about these settings, visit the documentation for the specific integrated system plug-in.
To open the configuration for a system, right-click on it in Project Explorer and click Configure.
Note: If there is already a tab open for the configuration, instead of opening a new
tab, the existing one will be navigated to.
| Setting | Description |
|---|---|
| System Name | The Name to use for the integrated system when listing it in Designer and Runtime. |
| Select Timeout (s) | The period of time (in seconds) until a selected asset will become deselected if no action is taken on it in Runtime. |
| Audit Command Execution | Check this box to log commands executed on assets. This is enabled by default. |
| Audit Status Updates | Check this box to log Status changes. This is enabled by default. |
| Sync Active Alarm Status Across Workstations | Check this option to allow alarms to be synchronized across Workstations. This includes masking, resetting, and acknowledging alarmed statuses. This option is enabled by default. |
| Asset Multi-Select | Allows the selection of multiple assets at once in Runtime. |
| Multi-Select is not allowed for alarmed assets | This option can only be enabled when Asset Multi-Select is checked. This stops assets which are in an alarmed status from being included in multi-selection. |