Add a Pan/Tilt Command

A PTZ camera can have custom Pan/Tilt commands sent to it. You can configure this within its Command Table.

To set up a new Pan/Tilt command for a camera, follow the steps below:

  1. In the Project Explorer, right-click on the camera's integrated system and click Configure.
  2. Go to the Command Table you want to add the command to.
  3. Under the Commands list, click Add.
  4. In the Action drop-down menu, click Pan/Tilt.
  5. Use the sliders to set how far you want to pan or tilt the camera in a direction when this command is executed. Leave the slider in the center to not pan or tilt.
    Note: You can set the numbers next to the sliders to configure the movement as well. For Horizontal Movement, left is negative values, right is positive. For Vertical Movement, up is positive values, down is negative. Leave the value at zero to not pan or tilt.